View Single Post
  #1 (permalink)  
Old 03-29-2016, 03:10 PM
Brett Proctor Brett Proctor is offline
Senior Member
 
Join Date: Jun 2010
Location: Las Vegas Nevada
Posts: 2,417
Default G100 Gelcoat gun

Bought this a while back anticipating that I would need it for when I started to build the side pods and the rear section.

Used it for making the mold for the rear section and it is sooooo much nicer than the other way I was spraying gelcoat.
Plus clean up is so fast and easy. Not much to clean. Just the lid and nozzle.

You can get different size nozzles and it can be used as a sand blaster.

In the HVLP gun I was using before if the resin started to cure in the gun before you were done(happened once) you pretty much had to throw the gun away.
Because there's nothing to the G100 gun cleaning the cured resin out isn't that much of a job.(haven't actually tested this out)

http://www.tapplastics.com/product/s...ay_cup_gun/175

Not as cheap as the HVLP spray guns but the time it saves spraying and cleaning up makes it so much nicer to use.
Reply With Quote